FPV Video Receiver 1.7G VRX Support FPV Goggles for FPV VTX Analog Receiver Module
I.Main Features
lChannels 8CH;
lSupport FatShark,Skyzone and other glasses VR headset display straight plug and analog
display and other connection use;
lHigh-sensitivity reception-97 dBm;
lEfficient DC/DC power input: 7-36V;
lSupport 5V voltage output;
lShort click switch channel;
II.Product Parameter
lReceiver (ground end):
lInput voltage:7-36V DC(2-6S)
lOutput voltage:5V/0.5A
lVideo system:PAL/NTSC
lNumber of channels:8 channels
lChannel selection:Short click switch frequency
lReceiving frequency: 1680-1960MHz
lSensitivity:-97 dBm(MAX)
lAntenna interface:SMA(outer screw inner hole)
lModulation type:FM
III.Transmitter operation and adjustment part:
1.Frequency table
| CH1 1680 | CH2 1720 | CH3 1760 | CH4 1800 | CH5 1840 | CH6 1880 | CH7 1920 | CH8 1960 |
2.Use a key to adjust the channel,short click switch channel,as shown in the figure below.
| Channel control short press to switch the channel |
| frequency | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
| channel | 1680 | 1720 | 1760 | 1800 | 1840 | 1880 | 1920 | 1960 |
| The green indicator light on | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
IV.Matters need attention:
lPlease install the antenna and then connect the power supply to avoid equipment failure;
lSelect the appropriate working frequency and set the transmitter to the same frequency as the receiving end(see the frequency table for details);
lThe input voltage is 7-36V(2-6S),do not use over the voltage range;
lThe output voltage current is 5V/0.5A.Please note that if the power is supplied to other equipment through the receiver output,the working current is limited to 0.5A.Do not use the voltage output end of the product over the 5V0.5A,otherwise the receiver may be damaged;
lBoth 5V and 5V-OUT are output terminals,do not connect to the power input terminal or the battery,otherwise it will cause damage.
|
|
FPV Video Receiver 1.7G VRX Support FPV Goggles for FPV VTX Analog Receiver Module Images
|
